engine pictures

[wi50]

Just for kicks, I've got a few pictures I'd like to share or a main cap assembly I built, could someone PM me with an email adress and I'll send them, or send me an email at [email protected]

I'm sorry, I'm not real handy with the computer, posting pictures, links etc isn't for me.

Later on I'll have some pictures of a new block assembly and new cylinder head allong with some information to put up also.

Thank You

 

[Anonymous-0]

I saw your lower bearing half girdle it should hold the lower in place well but what about the upper bearing half? They really get weak when material gets removed for big bores.

 

[wi50]

I made tie bars to hold the upper half togather when I made the girdle assembly. Those old blocks are weak enough to break in stock form. I got this one free because it was "scrap" when I started. May as well make it strong from the get go rather than have to change mind later.

 

[MRGJNV]

Post your e-mail as PM's don't work here. Wish they would get that going.

 

[Anonymous-0]

(quoted from post at 12:43:06 01/20/11) I made tie bars to hold the upper half togather when I made the girdle assembly. Those old blocks are weak enough to break in stock form. I got this one free because it was "scrap" when I started. May as well make it strong from the get go rather than have to change mind later.

Make sure even them long rods are hardened to a 40 rockwell . Just in chance you get the head flow right to make big numbers.

 

[wi50]

I put this up so that others to see, maybe they like to see what someone else has done. I like to see what others are up to, sometimes I can pick up on an idea or share an idea.

I keep no secrets, I alwayse give accurate and honest information, facts or opinions. I'd simply like to share some pictures of a project I did in 2002.

When I take the head apart to freshen it this winter, I'll put up some pictures and dimensions, numbers, etc. I worked hard on it allong with some verry good people.

 

[wi50]

when I click on "modern view" my email is in the original post. Once someone does me a favor I'll edit it and take the email out.

 

[wi50]

sometime I'll get some up of a nice flywheel and twin disc clutch assembly I made that fits in an allis with stock starter, bellhousing, etc.