Float ride seat

I was born at night, but it wasn't last night, and I still cannot figure out how to remove the lever assembly to replace the bushings and torsion springs! Do you bend the lightweight retainers in to remove the arms? Do I have to wait until midnight on a full moon to get this done? Any suggestions woul;d be greatly appreciated. I really appreciate the knowledge that is shared here.
LG
 
I'm familiar with the seats, but unfarmiliar with the names that you assigned to the parts in question.


Are talking about the short links in each corner? If so then no you have to push/hammer the pins out.

You may have to supply a picture or a part number to help the folks here to get to the proper conclusion of your question.
 
The little arms are held in by squedged pins. These pins, when rusty, will need to be driven out with a BFH and a punch. Good luck, and don't get confused tearing it apart.

Only buy the American Seat springs, as my indian ones are crappy. Woe to me for saving a couple of bucks.

Perhaps the most complicated seat i've ever worked on. An oliver seat, which uses the same springs, is very simple.

I about died rebuilding two of Deere's fantastic innovations. I had to machine and weld on new shafts and other wear areas.

I don't like the seat. I'd rather have a springy seat cushion on the non-float ride.
 
I did one a number of years ago and it is a kluged invention especially considering how well the replacement for it on the New Gen. tractors worked out. I do remember bending or springing some arms to get the pins out. I would recommend having the new parts on had before you take it apart so you can reassemble it immediatly while you still remember how it came apart. I was able to do it so most mortals should be able to also.
 
The solid piviot pins in each corner I use an air hammer to push them out. Then I use a C-clamp to press the new ones in.
The adjuster for the torsion rubber springs is held in place by roll pins. The plate with the adjuster decal is also held on by roll pins. This takes a long reach small punch.
I take the float ride assy. off the battery box and turn it upside down on a solid work bench.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top