Hello, all-
I have an early Ford 8N with a Marvel Schebler carb TSX241C. I had recently put new parts in from a kit. The tractor runs ok for a while then just stops and will not start. I discovered liquid fuel running out of the choke housing, lots of it. The first thing I checked is the float level, it is good if not on the low side, also it is not saturated. The gaskets all seem to be sealing properly. After I assembled the carburetor I set the idle and air fuel mixture both at one full turn off seat. I have not been able to properly tune the carb and governor because I do not have a proof gauge to properly adjust for RPM. The only thing I changed when I assembled the carb was I added the economizer jet from the kit which was originally missing. I am not very familiar with this type of carb so my question to the forum is, am I missing anything re: this serious flooding?
Thanks in advance!
-John
I have an early Ford 8N with a Marvel Schebler carb TSX241C. I had recently put new parts in from a kit. The tractor runs ok for a while then just stops and will not start. I discovered liquid fuel running out of the choke housing, lots of it. The first thing I checked is the float level, it is good if not on the low side, also it is not saturated. The gaskets all seem to be sealing properly. After I assembled the carburetor I set the idle and air fuel mixture both at one full turn off seat. I have not been able to properly tune the carb and governor because I do not have a proof gauge to properly adjust for RPM. The only thing I changed when I assembled the carb was I added the economizer jet from the kit which was originally missing. I am not very familiar with this type of carb so my question to the forum is, am I missing anything re: this serious flooding?
Thanks in advance!
-John