ford loader

Anonymous-0

Well-known Member
Hey All

i am looking for new packing's for 2 of the cylinder's on my front end loader. does anyone know where i can find them? also one of the cylender's is a little bit tweeked (bent) have been using the thing for about a year, bought it that way and would like to buy a new one... the shaft is 1 1/4 thick and about 32 inches long it is getting pretty weak and wont lift much weight now THANKS
 
I have found in the long run it is cheaper to have a hyds shop do the work. Hyd cylinders can be a pain the fix and if you mess up you eat the cost of the parts but if you have a shop do it and they mess up it does not cost you more. Also hyd shops are set up to fix thing like a bent shaft. Last one I had done cost me less then what the kit I found would have cost me
 
Yup,I took a couple of them in a few weeks ago. Cost me $20 apiece to have new seals put in them.
 
old and rrlund,
I wish that we had some good, honest hydraulic shops here, like you do. If you take a cylinder to get re-sealed here, it will cost more than buying a new one.
 
Just find a local machine shop that does a lot of work with hydraulics. They might straighten the rods... but they'll more likely want to replace them with new rod stock which is probably a better deal in the end.
A lot of those seal and packing kits from Ford are handy 100 bucks. Local shop might find a better deal. Might not... Probably best to just take it to them and let them have at it. 200 bucks per cylinder should cover it with a new rod.

I will reseal/pack them myself if the rods are straight or if I can tweak them back myself, but if they're bad, it goes to the machine shop.
Kits are too expensive to do the job the second time.

Rod
 
Rich - I just had the seal go out on the bucket cylinder of my Freeman loader (on my Ford 4000). I ain't the wealthiest guy around, so I told the local Hydraulics shop to just replace the rod end seals - and CALL ME WITH AN ESTIMATE. Even had it in writing. The guy calls me up two days later and says he ground the tube, polished the rod, cut the rod end loose, re-welded it, ground some welds, and a couple other things. His estimate was $230. He scoffed when I told him I could buy a NEW cylinder for less then that. I ended up paying him $25 for doing stuff I didn't tell him to do, and he even made it so I couldn't put it back together and live with the leak. He screwed up the old seals. I'm going to Surplus Center tomorrow to pick up a NEW cylinder that is actually better then the old one - for $90. They also sell seal kits, but he mucked up my old one to the point where I just need to replace it. I don't think I need to darken the local shop's doorway anytime soon.
 
Ya some shops are not worth the time to even drive up to. Guess I'm lucky we have a good not close by as in 25 miles from here that do a good job cheaply
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top