gaskets ? need help

[1965lonewolf]

need a pto gasket and the gasket that goes where the side pully used to be(6 bolt) design,i put a block off plate in both locations,tractor is a gtbd.
someone point me in the right direction ?

 

[ksmms]

go to napa, pick up gasket material . when you get home put the plates on it . trace it out with a pencil . cut along the line then install. This will save you the time waiting for it to be shipped. If you don't want to do the work call welters.

 

[ksmms]

go to napa, pick up gasket material . when you get home put the plates on it . trace it out with a pencil . cut along the line then install. This will save you the time waiting for it to be shipped. If you don't want to do this call welters.

 

[Philip moline]

Buy one tube of silicone apply and install done...

 

[okcass]

This company might have something to help you.
http://www.lubbockgasket.com/moline_engine_parts.html#gaskets

 

[1965lonewolf]

NO KIDDING DICK TRACY..

 

[1965lonewolf]

THANK YOU SIR , NOW THATS HELP, I KNOW I COULD MAKE MY OWN BUT I WANT SOMETHING THATS ALREADY DONE AND MADE TO FIT AND LOOK 100% FACTORY AND LOOK NICE.

 

[Anonymous-0]

Hey Lonedog - Dick Tracy had a good quick solution/suggestion. Every suggestion is a little different and he gave a quick inexpensive solution that would look as factory as any purchased gasket that your never going to see anyway. If you don't like silicone, cut a new one out of gasket material. Again, it looks as good as any other OEM part you can't see...

 

[Anonymous-0]

This is the reason I will never help you though all the different posts you have made on the tractor. What an attitude and we have seen it before too. It is a wonder you get any response at all for help. Smarty!

 

[Dieselbear]

I'll agree with that

 

[MM diesel]

me too!!

 

[Molineone]

Amen. Lonewolf, I will not help you for the above mentioned reasons. Use a little tact and respect, and you would recieve more help than you would need. Something tells me that you will never change.

 

[J.Wondergem]

Me three!!

 

[Jake Winn]

Im right there with you guys. I tried to offer some advice at one time as im working on a GBD as well and recieved a less than pleasant reply. Not to smart to bite the hand that feeds you.

 

[1965lonewolf]

you are all correct but that being said and we all work on tractors that someone coming back and saying just you silicone out of a tube , i would take it for granted that everyone would already know that. so i thank everyone for there help and i did get them at welters.I am sorry if i offended anyone.

 

[1965lonewolf]

you would think that with all of us working on old tractor and trucks that we all know the last result would be silicone , its kind of a gimmie , so no disrespect but silicone everyone jnow will do it and we all have used it .

 

[MMfan]

Welters is the answer to most of the things you ask for that are factory parts. You call them and they know what you are talking about and get you the correct parts.