Gleane E engine in unstyled WC

[redd720]

i got me E engine. i want to make sure i got enough information before i start working on WC. I am installing gleaner E motor in unstyled WC for pulling.

All I have to do is: install WC or WD45 flywheel on E, install WC govenor, Wc water puump,and WC water manifold. Is that right?
What about timing cover and crankshaft pulley? Leave it on E or change it to WC timing cover and crankshaft pulley?
Thank you for helping me.

Tracy

 

[Pig_Iron]

You better check the rules where you plan on pulling first. Alot of places dont like to see a wd45/d17/gleaner E block in a WC or WD. Sounds like your on the right path as far as the swap. Youll need to block off the fuel pump, and do a bit of oil line work on the right side of the block so they will clear the steering shaft. If you really wanna make it run, throw a set of wc flat tops in that gleaner motor and run a 175 allis spring.

 

[Anonymous-0]

Tracy in order to get the belt to line up with the wc water pump youll need to have the wc pulley bored to fit the combine crank snout.

 

[redd720]

ok thank you so much
Tracy