header/intake

[Oliver 88 Puller]

Who makes the custom header/intakes for the 12 port Olivers and estimated costs? Thanks for any help!

 

[S.D.L.]

The few guys I have talked to that have made some on the past have quit making them due to the complexity of having all the ports. There is probably somebody out there that will still make one I just haven"t found yet. I was thinking about making one myself, but that will be a little while.

 

[unknownm]

fabshopheaders.com (naturally aspirated) under the pulling section (very!!!!!!! costly)

 

[Anonymous-0]

Its not to hard . Just order you a header kit from jegs and tack it up and weld it with it on the tractor . Make sure you put wet rags on the ports on the head . That way weld slag want get into it . Also plug up the intake hole . When it cools down then you can take it off.

 

[baldwin racing]

you may even want to look into www.mtechsupply.com at the model 3 tubing bender...and just buy the diam die you need with the tightest bend for 180 degrees or clr this is what i use to build atv drag chassis with out of 4130 chromoly and does not kink has perfect bends everytime.....just may have 5-600 in it and have the the base plate for intake and head plasma cut out....
hope this helps kelly

 

[baldwin racing]

the first one it will take a while and money but right every bend down and at what length you bent it at along with what length pipe you use then the second one will be easy for you.....if you decide to make them....

kelly