help id my old cutter

bill h

New User
rotary cutter is rectangular and 5 foot wide. the only infor i have is that there is part of and old decal on the sides the remainder says "m b special" (white decal with black letters anybody seen one of these????
it runns off of the power take off and has a tail wheel made of scrap tires bonded together. it is rusted and old so i dont know a color. it does not appear to ever have had any flying debris deflectors hanging from the rear discharge. it has 2 sets of angle iron welded to the deck as stiffeners in a cross pattern making a box around the gear box. an 1.5 to 2 inch pipe goes from the tail wheel up over the gear box with braces welded to the top of the gearbox.
i need to replace the gearbox but dont have a starting place. thanks for your interest
 
It's probably a BMB; they are no longer in business as a separate company, having been bought out and I don't remember by whom. Try googling BMB.
 
most of those gearboxes mount up the same...shouldnt be much of a chore to find one that'll fit unless youre trying to "restore"... try your local indy dealer.
 
before you spent too much on the old machine, i would look at some used units.

I see them all the time for $200-300
new you can buy them for about $550
these are considered light duty units.

a rotory cutter (bushhog) is under alot of stress when you are cutting and blades are spinning fast, a unit in poor condition could get you or someone else hurt. Be sure the frame and stump jumper are all in good shape before you dump alot of money in this old machine.
bushhogs are dangerous machines,
your safety and safety of others is a must

good luck and stay safe.
 
BMB was bought out by Rhino probably 15 years ago. They used the same plant to make Rhino cutters until about 5 years ago. BMB company was started up in Holton, KS. in the late forties. Just about every farm sale around here has one of them cutters on it.
 
thanks, i figure buying a gearbox and coupler would be cheaper than buying whole unit. blades, jumper and deck are in fair to good shape. when i got it 10 years ago the lower oil seal was shot and used it a little then set it up for a long time, now i have a use thanks again
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top