How did your day go?

37 chief

Well-known Member
I started off by hauling around 10 telephone poles I plan to use for a shead for tractors. I was mowing, and blew out a special fitting on one of my power stearing cylinders, but I had a spare. I needed oil, and I was about a mile from a Napa store. So far so good. After my tractor was on my trailer I heard air comming from my rear tire. That was the end of my mowing for this day. Took the tire to get it repaired. They charged around 45.00 for a flat repair. I guess I will go back to repairing my own again. That was about my day. Stan
 
Today was pretty good but yesterday afternoon sucked big time. Worked all day on a gas piping job and got home around 6:00pm. Had a office chair ordered at Staples and went to pick it up. Decided to drive the Isuzu Npr flat bed because I needed a couple things at Tractor Supply. Well about a mile from town, the vacunm, brake light and battery light came on than I heard a sonic boom and saw a big cloud in the rearview. Pulled off to side of the road and tilted cab up. Antifreeze everywhere and saw busted top radiator hose. After steam cooled down I cranked engine to see if it would crank. Noticed the alternator and fan not turning. Shut the engine down and found that the harmonic balancer had seperated. Called five wrecker services and no one wanted to come out. Had ball games, couldn't tow tilt cab and other bs. ------ off called kin folk and took old hose to Autozone and got something close. Bought three gallons water at Foodlion .Went back to truck afroed hose and poured water in. Cranked up and drove about eight miles to service station. Stopped because truck started to heat again. Left overnight and went back today. Cranked up and got home. Ordered new harmonic balancer for $210.00. Now there are five towing services that will not ever get a call from me.
OK I feel a lot better now. DH
 
Spent my day at a military vehicle museum in Central Indiana. If you are ever around Crawfordsville be sure to visit the Ropkey Armored Vehicle Museum. An absolutely fantastic collection of military vehicles, some from WWI. Old iron is old iron, and I really enjoyed my day.
Paul
 
Wasn't too bad here- I stayed a little bit later at work and started making new shafts for the corner wheel bases in our barn cleaner. Making 12 of them this time- Just need to cross drill the grease hole and slot it to go along the entire bushing.

Went home and fixed a universal joint on our manure spreader, but while greasing the rest of it grease came out a broken cap on the other side of the joint. Now I'll have to try removing the shaft from the spreader to fix the other joint. Might be able to use the 2 good caps from the other replaced joint, but I'd have to try getting it apart without wrecking the rest of the caps.

Helped unload a wagon of hay that we bought- Was a 9x18 kicker wagon stacked 2 layers above the cage. Something like 220 bales on that wagon. When they were leaving I saw the back tire on the wagon was shifting side to side, so Dad called them at home and left a message to check the wheel bearings- He was talking about selling hay to a guy who is 75 miles away this next week.

Took my 1600 for a drive around the country block (probably 5-6 miles) just for the heck of it. Was kinda fun.

Donovan from Wisconsin
 
Spent the morning moving animals and setting up fence for the weekends moves. VERY nice to be feeding grass rather than hay. In the afternoon, cultivated the potatoes and spinach, by hand. We sell at farmers market and in town, so we have quite a bit planted. Pretty warm today, but not unpleasant. Got a good dose of sunburn on my arms, face and neck. Now, wasn't I running the woodstove at the end of last week????

$45 to repair a flat. What kind of truck were you driving? I've never paid more than $10 locally to repair a flat. Usually we can get it done for a couple dozen eggs and my wife's winning smile.

Christopher
 
Good day in nw alabama, good enough to take the day off. Mid eighties, no clouds and a good breeze. Replaced the rails on the deck, cut some grass with the kubota, replaced the tachometer drive cable on the 71 ford and then disced up a spot for tomatoes which we then planted. The 3 S"es felt good tonight "shower, supper, sofa". Another busy day tomorrow with a new experience, replacing some disc blades on our son's disc, should be fun, after that will help him plant some pecan trees.
 
Got laid off last week. Insurance was to be good to end of April. Went to get prescriptions filled today, insurance canceled already. This afternoon took my tractor to friends to borrow his disk,about 2 miles away, half way there tractor started starving for gas. Was able to limp it to his place. Hopefully will get it fixed tomorrow
 
Finished house wrecking job on the edge of America {Folly Beach SC. south of Charleston}. Load excavator on lowboy when my brother shows up with it. I always drive when we move it, get a few miles from job when it thought I heard it sputter on a gear change. Call brother on radio to find out if truck has fuel. He assures me it should have plenty. Pass nice station that has diesel and I am about to start up long bridge when it shuts off This time I am out, in right lane Can not get off road for high curb. After several attempts to siphon fuel from excavator send brother to station to get fuel. Finally get going and get back to shop with plenty of time to get to bank and cash check. Stop at land lords office to get another check and spend to much time talking, bank closes. Go home with pockets empty except for beach sand. Not a bad day but it was 90 degrees and I am not ready for that yet.
Ron
 
Sent trucks to the sand pit , got there and found someone stole a hydraulic cylinder off the loader, just cut the hoses. Boss picked up the big excavator from my job, took it home to use it, caught on fire and burned to the ground 2 hours after I finished using it. My company pickup started running like crap, had to take it to ther dealer. Haven't heard what is wrong with it yet. Not a very profitable day.
 
Gotcha.

One of my tractors (the one I use the most) has a slow leak in one of the rear tires. Kind of busy with it right now and don't want to have downtime to take the tire off and into town. I'll have to bite the bullet before hay cutting time, though.

Christopher
 
I don't think anyone in all of Wisconsin (atleast not within 75-100 miles of us) is even thinking about corn till it wamrs up a little bit. We did get our oats in, which can handle the cold. Been raining on & off since we got done on Saturday, and not any real heavy fast rains either. All soakers that do more good and we needed it. The ground was quite dry when I was drilling the oats.

I've been working on the corn planter this past week to get it ready. Adjusted the seed rate for around 30,000/acre, and dropped the fertilizer rate as last year it was put in way too heavy. I think by back figuring that we have the low rate augers in our planter (495A) and I set it for about 160 lbs/acre. Last year was almost 2x that and that was waste. Got the planter ready to go now.

Now we just need to get the fertilizer, after we figure out how many acres we actually have to plant. Right now we have 2 bigger feilds, but can't remember off hand how many acres they are without looking at plot maps. Got 1 or 2 more hay feilds we're looking at plowing under later on, but then we'll order more fertilizer if we need it for those feilds.

Next week's project is fixing the apron chain in one of our boxes, and maybe putting it on a different running gear.

Donovan from Wisconsin
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top