DaveBN
Member
- Location
- Western lower Michigan
Cousin has a Hustler Super Z zero turn mower. It's a 2010 model. We
think one of the coils or plug wires are bad as it will run rough after
one to two hours of use. Dealer has worked on it twice, cousin has
worked on it with no improvement.
My question is that it looks like a big job to get to the coils to
replace them. If the Kawasaki engine cover has to come off then the
mower looks like it must be mostly dissembled. It is a Kawasaki 850
engine. Can we cut an opening in the engine shroud to get to the coils?
Is there an easier way?
Hope someone here has experience with this.
Thanks
Dave
think one of the coils or plug wires are bad as it will run rough after
one to two hours of use. Dealer has worked on it twice, cousin has
worked on it with no improvement.
My question is that it looks like a big job to get to the coils to
replace them. If the Kawasaki engine cover has to come off then the
mower looks like it must be mostly dissembled. It is a Kawasaki 850
engine. Can we cut an opening in the engine shroud to get to the coils?
Is there an easier way?
Hope someone here has experience with this.
Thanks
Dave