Hydralics schmatics

Osc27

New User
First thanks for the info from before but I need to know more about running the hydralic lines for the flow and the return Can any body help?
 
What are you trying to accomplish ?? I can give you a quick run-down as to what constitutes a simple hydraulic system...First a reservoir with an outlet and return , A non pressured fill cap , and a suction filter of sorts[usually a screened covered cylindrical shape that screens the oil of large solids] to prevent large solids from tearing up a pump..Next is a pump..Larger fitting size is the suction side..Always use a hose thats marked suction hose..Hydraulic hoses used here are known to seperate the inner lining from the inner steel wire and cause suction flow problems..The smaller fitting is the pressure side out..Always use at least 2 wire hoses for pressure applications..Pumps come in different rotations[ clockwise or counterclockwise]..Next is the hydraulic line from the pump outlet to the control valve..The control valve should be marked inlet and outlet..Also the control valve should contain a system relief to protect the pump from overpressuring..Connect the other 2 or more lines to the individual functions..Then the return hose from the control valve to the reservoir..[I would install a return filter on the return line to the reservoir to filter out any impurities before they get dumped into the reservoir]..
 
I did not see your other request for information. There are tables for selecting line sizes for hydraulic systems to avoid heat & pressure drop problems. Also remember your return flow will exceed pump output in most cases. How about more details or an e-mail address. J.
 
Mr J.Schwiebert Here is the deal.I have a Farmal M.The hydralic pump is not strong enough to do what I need to do.I have another Pump from a fork lift and I plan on incorperating it to the side flywheel>now I do know that the rpm is only about 866 for the side flywheel so I have to increase the size of the pully for the pump.I then am running into the problem of flow from the pump to the controls and then back to the holding tank.Do you think that flow through valves are the way to go?Then I am running into another problem which is can I keep it at a gravity drop or do I have to redo the rams and seals for both direction use?
You can email me direct at [email protected]
I am only at the house on weekends so I may not reply during the week.
Thanks osc27
 
There is no way to answer your question since you have not said what you want to do. Secondly, you probably need to do some research in order to understand the basics of hydraulics. Flow is not the answer to making a system "stonger". Pressure is. Flow is faster. You have to have flow through the valve if you have an open center system, which most fork lifts are. By side flywheel do you mean belt pulley? Does the pump have strong enough bearings to running on a belt? Most do not.
 
the pump which I have found out is from a forklift.It's about the size of a starter with splined end If I put a say 3in pulley on it and then mount a 5in off the side flywheel that should be about the rpm for the pressure of the pump to run I am going to build the whole thing basicly from scatch or pick up the parts I need for the project What this unit has to do is be able to lift about 1000 lbs from the front or the back.Note it has a front bucket and a homadew three point hitch for the back.It's for moving the bales into the barn from the field.Doorway is justbig enough for the tractor anf don't want to make it any bigger.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top