(800) 853-2651
SHOP NOW

IH Engine ID Help

Yesterday's Tractor Forums
A

Anonymous-0

Well-known Member
I bought a complete International power unit that came out of a Gallion wheel roller. If the hour meter is correct it only has 957 hours on it. I believe it since it is very clean and runs very smoothly. I am going to put it into a 460 with a blown engine. I know the engine will fit but I was wondering if I can determine the displacement from the engine serial number? I have not been able to find anything on the internet yet.
Thanks
 
On the block by the oil filter base should be a machined flat surface with numbers stamped in, should begin with a C for gas then 221/263/282/301 for cubic inch of engine, diesel would be D, then 236/282/301. Then serial number usually 5 to 6 numbers.
 
You must log in or register to reply here.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top