IHC Plow

[Anonymous-0]

Just aquired an IH 3-14 trip plow converted to hydraulic. Plan to convert back to trip. I am looking for new tail wheel rim. Any suggestions as to where one can be purchased?
Can not locate model number or manufacture plate.
Any suggestions as to where for find the model nmber?

 

[Anonymous-0]

I have ordered a new blank 4" x 12" rim from M.E. Miller Tire in Ohio before and cut the center section out of the old rim. The new rim was a little wider than the original but a 4.00 X 12 tire fit on it. Just take your time and cut around the weld and grind off smooth. Be sure to measure carefully to make sure your wheel is the same on all sides when you weld the rim together. The center section sits on the edge of the blank rim. Any questions e-mail me.

 

[Anonymous-0]

Thank You. I kind thought this would be the only repair process. I appreciate knowing to keep both sides are equal.

 

[Spudland_Dave]

Just aquired an IH 3-14 trip plow converted to hydraulic. Plan to convert back to trip. I am looking for new tail wheel rim. Any suggestions as to where one can be purchased?

Would the parts from the Hydraulic Conversion look like the attached Photo?
If so, I'd be interested in buying them from you to convert my IHC #8 over to Hydraulic from Trip.

As far as your tailwheel rim...whats wrong with yours? I've seen people fix em several ways. If its just the rim thats bad, cut it out and weld a new blank rim to your factory center.