Injector Puller

[Anonymous-0]

I need to remove the injectors in a CASE 500 Diesel. Same style as GVI. Has anyone come up with a puller? They will not come out! I really do not want to drive them out through the fuel cell hole. They must be coooked in there! Please Help. Thanks! Any ideas are welcome.

 

[Anonymous-0]

Do you have any little pry bars often called rolling head pry bars or "lady fingers"? You may need one on each side of the nozzle holder.

 

[Anonymous-0]

Tried that.

 

[Jake Winn]

Does the tractor run? Sometimes you can warm it up, then loosen up the nuts that hold them im, start it up, and the compression can help loosen them.

 

[Anonymous-0]

Pull the hold down studs out spray with penetrent and twist back and forth and keep spraying.Also I use a slide hammer and make a adapter out of a old injection line nut that fitts the injector but I think yours exits out at 90 degrees maybe make a fork at will slide under the hold down but make it as stout as possable

 

[Anonymous-0]

combine some the ideas below. try some heat. If it does not run it is OK to put a little fire to it. If you get the head to operating temp and pry on them with the tools described they should let loose. Buy some of that "Loved by many laughed at by others" Kroil from Kano.....works wonders around here.

 

[Martin Lucas]

Try a product from Lawson called BRREAK. It is one of those freezing type penetrants. I've used it for a lot of stuck stuff. I usually spray it on, wait a while and then reapply until it just breaks free.
I get about an 80% success rate. Good luck, Marty