It's that time again

[Anonymous-0]

sleeve in block is 5.080 od/4.875 id . sleeve and sleeve tool is 4.980 od/ 4.625 id . the above block just shows how far you can go

 

[CLIFF S]

Is this a Allis?

 

[Dblair]

is this going to be your new puller Mitch ?

 

[Anonymous-0]

Its a allis d-17 226 block . Dblair its a customers. Some say 4.875 bore wasn't possible on a factory 5 inch bore spacing so i thought a picture might help. 5.080 od sleeve with a 4.875 id leaves a .1025 wall thickness

 

[matt bock]

nice of u to put ur thumb in the way so u cant tell where the end of the tape is nice trick photography.

 

[matt bock]

I like how u put ur thumb in the way so u cant tell where the end of the tape is.

 

[Anonymous-0]

the tape just gave reference incase the numbers on dial caliper didnt show up in picture . however the numbers on the dial caliper show up well

 

[Anonymous-0]

(quoted from post at 11:08:45 06/10/13) nice of u to put ur thumb in the way so u cant tell where the end of the tape is nice trick photography.

Maybe this picture will help you out . no hoodo from tn.