I have a 1966 1020 Gaser. 12 volt system. I am experiencing charging problems. Generator light is on. At first I thought it was the alternator as I was only getting a voltage reading for what the battery itself was putting out with the tractor running, about 12.3 volts (after trickle charging due to the no charging condition). After replacing the alternator I saw no change in the voltage. Through some research, I decided to consider the voltage regulator. I brought direct power to the field terminal on the alternator and the voltage on the multimeter at the battery immediately jumped. Thus, I suspected that the regulator must be faulty. I Replaced the voltage regulator and am still only getting about 12.3 volts at the battery with the engine running. When running and turning on lights, I see the typical drop in volts from the battery. Increasing rpm produces no change in voltage at the battery. So, the alternator is still not putting out a charge. From what I understand, the output should be 14 volts give or take. What am I missing? What should I do next? Thanks in advance for any suggestions.