I agree with all , but the handy to use.

I guess it depends on what you NEED to do too ?

They are alot better then an A or 60 but surly not as nice as a brand new JD 50 hp with hydro tranny and cab and loader.
 
Fine for field work, haying, etc.- but a utility tractor, it ain't. Miserable with a loader, because you don't have enough hands. Not "handy" in tight places.
 
Depends on what you grew up with. I grew up on Deeres and am very comfortable running a two banger with a hand clutch. The person who grew up with a foot clutch will have a hard time learning the little tricks that make running a hand clutch easier. Jim
 

Had one, used it, sold it, after some years bought it back with intentions to restore, have lost a lot of interest and have trouble finding time. Tractor is powerful, will pull 18 disk offset harrow with 9 inch spacing ok. Liked it for bush hog work because you are up above the flying trash. Down side is you are sitting up there without fenders to protect you. When disking, heat from the exhaust manifold radiates up to the gas tank and makes gas boil out of the tank. Put vent tube in cap and gas would come out of that. I don't mean literal boiling, but the gas did get warm enough to expand. Reports at the time indicated the problem was not limited to JDs, Farmall M was mentioned, but I have never owned an M--yet.

Foot pedal for pto simplifies pto work, which is needed because of hand clutch.

Visualize using tractor to move round bales of hay with 3ph forks. You have to back the tractor, steering with one hand, while using the hand clutch to stop tractor at proper point, then use the right hand to work the hydraulic lift. A little awkward.

The cat II 3ph is great and I haven't seen a more modern one that is any better.

Didn't have any complaints about the steering, even though it is non power.

Fuel economy was not bad.

Never could get the starter to spin that big 2 cyl very fast and cranking could get interesting.

Referring back to gas boiling, I don't think it did that in cold weather.

KEH
 
plow hand,
Well I guess it depends how reasonable his price is.For some reason the sales prices aren't real strong on that model even with all the bells and whistles.

Vito
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top