john deere G Or A build

[Anonymous-0]

Where is the best place to seek good information on building a mild puller. I dont want to cut trans housing. I need some experience on what to do. I have an A and G. So many horror stories on this forum about people not satisfied with who they dealt with . Who do you suggest.

 

[4010 puller]

Is the A fast or slow tranny? What speed class will you be pulling?

 

[Josh Blackburn]

Give me a call.... I can make parts and give you alot of good ideas 9892775366

 

[north puller]

Google Murphy's Motor Service or Extreme Tractor Parts. These two can do mild but specialize in BIG. A good two cylinder man who will talk to you about a mild build is Bob at Tripple G Services. He's not on the web. Call him at one tripple eight 720 - 0830.

 

[buickanddeere]

Mild of low $$$. How deep are your pockets? What class are you pulling in?

 

[V-n-M PULLIN]

alot depends,, depend's on weather you buildin styled or un-styled,, far as i am concerned ain't nothin like a un-styled tractor woopin some butt...

 

[jdth]

I hear that!!!

 

[puller 1]

i was thinking about getting murphy's 9.5 stroke and 7.5 bore kit. is this a good setup?

 

[gtx1967jewison]

$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$

 

[Josh Blackburn]

If you can afford 4500 for the block go for it you can get the same thing for 2500 from golder. His big blocks hold very well. He builds a good crank too for 8 to 900