tlrountree
New User
Was shredding the pasture everything working great. Stopped to speak to my uncle. While stopped I had my foot on the clutch, engine was running, Independent PTO was turning, everything was normal until I let off the clutch and nothing happened, the tractor did not move.
There was no noise in the transmission, I stepped on the clutch and cycled through the gears and let out the clutch for each gear and no luck. Then I cycled through the gears without the clutch and there was no grinding of the gears as you would expect. I checked fluid level and it was a little low. Added fluid and went through the same sequence of the gears with no change.
It sorta seems like the clutch is stuck in the engaged position since when changing gears with engine running and without me stepping on the clutch there is no grinding.
So any trouble shooting tips or suggestions would be greatly appreciated.
There was no noise in the transmission, I stepped on the clutch and cycled through the gears and let out the clutch for each gear and no luck. Then I cycled through the gears without the clutch and there was no grinding of the gears as you would expect. I checked fluid level and it was a little low. Added fluid and went through the same sequence of the gears with no change.
It sorta seems like the clutch is stuck in the engaged position since when changing gears with engine running and without me stepping on the clutch there is no grinding.
So any trouble shooting tips or suggestions would be greatly appreciated.