M-M 445

[dan field]

can you guys help me again mowr filled me in on hyd fluid locataion and said it takes tran fluid is this auto trans fluid if so what type also is there two fill holes for gear oil if you have amplitorque and what weight gear oil would it take thanks !!!!!!

 

[yellow is good]

trans oil is usually a10 weight oil or hydraulic oil like HY Gard,, Trans Gard,, 123 etc. your tractors operators book, I think says 90w gear oil maybe not ?????? any way drain your trans and torque the torque drain is down on the left side by the pivot for the culch petal,, filler location is by the shifter torque will fill by splash oil from the trans I run 50 wt to keep grar noise down ,,,,,,BOB

 

[dan field]

yellow is good thanks for the help

 

[Anonymous-0]

The books originally called for type S hydraulic fluid. A modern equivalent is Dextron III.

Lots of guys do run Hytrans or an equivalent in the hydraulics so they can swap implements with other make tractors and have no problems.

90 wt was original spec oil for the transmission.

I read somewhere that 50 wt motor oil and 90 wt gear oil were the same viscosity. IF its gear lube its measured differently for some reason.