Me again. While waiting on my fuel tank to
get repaired I'm working on a few things.
My tractor has dual remotes. One set of
remotes is being used for my FEL. The
other set will be used for my round baler.
Problem is, the handle that controls the
other set of remotes appears to have the
roll pin sheared off that makes the rod
and handle move. The handle moves back and
forward but the rod it's supposed to be
hooked to, does not. Can't drive the roll
pin out because there's no way of knowing
where the hole is in the rod in comparison
to the handle. Its a 5/32 roll pin. I
tried drilling it out and broke 2 bits
rather quick. Any tricks to getting this
out. I was looking at taking the whole
axillary setup off and figure out how to
get the handle off but would rather hear
from you all first. Guy said it was that
way when he bought it and never messed
with it. Thanks in advance.
get repaired I'm working on a few things.
My tractor has dual remotes. One set of
remotes is being used for my FEL. The
other set will be used for my round baler.
Problem is, the handle that controls the
other set of remotes appears to have the
roll pin sheared off that makes the rod
and handle move. The handle moves back and
forward but the rod it's supposed to be
hooked to, does not. Can't drive the roll
pin out because there's no way of knowing
where the hole is in the rod in comparison
to the handle. Its a 5/32 roll pin. I
tried drilling it out and broke 2 bits
rather quick. Any tricks to getting this
out. I was looking at taking the whole
axillary setup off and figure out how to
get the handle off but would rather hear
from you all first. Guy said it was that
way when he bought it and never messed
with it. Thanks in advance.