Well I got delivery of a new rad for my 35, got the old one out with no trouble.
I go to put the shroud on and it doesn't sit quite right.
I check to see how it will fit on the tractor and find the water inlet and outlet aren't at the proper angle and the piece for the support rod is in the middle of the upper tank above the water inlet. On the original it is just to the side of it.
The part number is correct I think, 186830M91 for a gas engine.
Are they all like this, or could it have been labelled wrong? Should I re-order?
Anyone else replaced a rad and had this experience?
It says on the box that it was made in Ireland and has an A&I sticker.
I'm suspicious that it's for a European version
I go to put the shroud on and it doesn't sit quite right.
I check to see how it will fit on the tractor and find the water inlet and outlet aren't at the proper angle and the piece for the support rod is in the middle of the upper tank above the water inlet. On the original it is just to the side of it.
The part number is correct I think, 186830M91 for a gas engine.
Are they all like this, or could it have been labelled wrong? Should I re-order?
Anyone else replaced a rad and had this experience?
It says on the box that it was made in Ireland and has an A&I sticker.
I'm suspicious that it's for a European version