Randyr

Member
Well I got delivery of a new rad for my 35, got the old one out with no trouble.
I go to put the shroud on and it doesn't sit quite right.
I check to see how it will fit on the tractor and find the water inlet and outlet aren't at the proper angle and the piece for the support rod is in the middle of the upper tank above the water inlet. On the original it is just to the side of it.
The part number is correct I think, 186830M91 for a gas engine.
Are they all like this, or could it have been labelled wrong? Should I re-order?
Anyone else replaced a rad and had this experience?
It says on the box that it was made in Ireland and has an A&I sticker.
I'm suspicious that it's for a European version
 
The early TO 35's vs. later MF ones had a slightly different radiators....just a part of an inch different. It also sounds like your might be for a british FE35. If you have the old one just have the core rebuilt...much better than the import rads.
 
I called the dealer today and they will take this one back and order one from AGCO parts. She said it will be an oem type. We"ll see how it goes.
I did look up AGCO"s Heritage line and saw that the TO35 part # is 186830v91. The new one I got is 186830M91.
For a 35 the # is 894319v92. So maybe I got one for a TO and not a MF.
I"ll call them tomorrow to see what they ordered.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top