minn-moline 670

Is this horizontal lever located on a plate that measures about 2" by 4" under the seat?
If so there should be 2 levers or at least the remains of 2 levers. One controls the drop rate of the 3 point. The other controls how fast the draft control cycles.
 
the machine I have been trying to figure out has a 4inch round plate under the seat with one lever.Doesn't really look like one lever is missing.
Also,if the drop rate is wrong ,would that restict my return flow and cause a squeal??
 
As far as I know, MM never made a round plate for the levers nor one with only one lever. None of the parts books I have show such a thing either.
I would assume that someone lost or damaged the original and made the replacment that you have now.
Without knowing what that lever is affecting in your unit, it would be difficult to tell if it is causing the problem. You could remove the plate and start it up to see if you still have the noise. You may loose a little oil if it is full or over full. Having no levers means that you couldn't control the drop rate or the cycling of the draft control but if the noise disappears with the cover off simply repkace it with the correct plate & levers. When installing the plate, turn the levers so both pins that stick down are as far forward as possible then set the plate down a bit forward of where it goes & slide it back after it is sitting on the casting.
John
 
Could it be a type 'E' hydraulic system with just a tank and control valve under the seat?

Does your 3- point have separate cylinders that lift it, or is the cyinder inside the housing under the seat?
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top