Model C clutch installation

[Anonymous-0]

Installing clutch plate, pressure plate, throw out bearing and not sure of the measurement for the 3 fingers on the pressure plate that the throw out bearing contacts. Any advice would be appreciated. Deans

 

[Jim350]

They are 1 & 13/16"'s from thr clutch disk to the surface contacted by the release bearing.

 

[JoeinMN]

(quoted from post at 03:24:51 04/17/11) They are 1 & 13/16"'s from thr clutch disk to the surface contacted by the release bearing.

Hi I'm doing the same job. Is it necessary to adjust the new pressure plates or do they come pre-adjusted?