Mortar mixer

[Walnutguy]

Looking for something like an Imer 750 or 480 vertical shaft mixer, expensive to buy new, hoping to find good used? any leads appreciated

 

[FMS-KS]

I have a vertical shaft concrete mixer. Is that what you were looking for?

 

[Walnutguy]

yes, it is

 

[Walnutguy]

What do you have, and how much? Thanks

 

[FMS-KS]

I have a Montgomery Wards hand concrete mixer. It can either use an electric or gasoline motor. I have used old used electric motors to operate it. It is one that one can shovel the cement and aggregate into the mixer and then dump it into a wheel barrow that one may move the concrete to the site to be poured. I will have to decide how much I want for it if you feel you can use it. It is located in SE Kansas and would probably cost more to transport it than it is worth. I do not know where you are located.If you feel you are interested I could drive to the farm on Monday and take a digital photo of it and sent it to you.

 

[Walnutguy]

I am near Tulsa, probably not too far away. Do you know what the capacity is approximately?

 

[FMS-KS]

I am located about 130 miles from Tulsa. With the handle you are using I am assuming you would like to use it to clean walnuts.I have used this one several times to wash walnuts and to clean them after they are washed. If one throws in a few large rocks it cleans them up pretty good.

I have also used it to pour a patio, sidewalks, and some extensions to my drive in Pittsburg.

 

[Walnutguy]

I have a Harbor Freight one I have used to husk walnuts.

Actually I need this one to pour molds, I think I would like a pretty large one, maybe 12 cubic feet. do you know about how large yours is?

 

[FMS-KS]

According to YTmag rules we are not to advertise on or sell items on this forum. Therefore, it will be necessary for me to obtain a digital photo and place an ad in the YTMag photo ads if we wish to communicate further in regard to the concrete mixer.You will be able to review the ad after I place it in the photo ads section. I will try to do that Monday, July 6th.

 

[Walnutguy]

ok, I'll check it

 

[FMS-KS]

Mine is a small batch mixer. About 4 or 5 cubic feet.

It is posted on the Photo Ads under Tractor Related Items.