old
Well-known Member
- Location
- Camdenton Missouri
So yesterday I put a new cutting edge on my W Speed Patrol. I then started it up to move it around so I could cut the extra part of the cutting edge off and it would run for a bit then start coughing and acting up and popping back from the intake of the carb. I got it where I need it to cut the ends off and let i9t sit. I fired it up today and a short time after I fired it up it started to run bad again. I did get about 1/3 of my driveway graded but when I went to go up the hill it would not pull the hill. Got it back home and checked fuel flow. Not good out of the carb drain but good at the line where it hooked to the carb. I messed it it a bit more and fired it up and let it run for 30 or so minutes and no problem at all. I then let it sit for about an hour and figured I'd fire it up and let it run and see how it did. Well it is sitting and running just fine right this minute. So maybe what ever was clogging the carb up has not worked it way out of the system. But if that has happened it seems a bit odd for it the have happended