pulling e-gleaner

[vern-45]

i just got my e-gleaner engine home last weekend.i will be rebuilding this currently stuck engine into a hopefully decent pulling engine.175 cam is in the works.i believe,this motor is the M version,i think the comp.ratio is only about 7.2to1.i have a set of wc flat top pistons and rods,will they fit in there and will this raise my comp. ratio up a bit?thanks!

 

[Anonymous-0]

measre the piston from the top to half way down on the pin hole . give me that height and i can figure youre compression ratio for the piston in question also state if it has a dish in the top . If it does get a surenge thats marked in cc and tell me how many cc it takes of water to fill the dish.

 

[Mike Bock]

dont use the WC rods the are not very strong ,they are the same length as your gleaner rods, use them

 

[vern-45]

i don't have the pistons out of the block,but the head is off. the pistons are flattops.more info to follow later.thanks.