Re: Re: mead speedcat

Anonymous-0

Well-known Member
This message is a reply to an archived post by Ivan Leaders on October 03, 2000 at 17:18:04.
The original subject was "Re: Re: mead speedcat".

I am searching for an answer! You have had your mead Speeddcat apart and I am at a standstill! I have a puller on the clutch plate, with a bolt indside the pilot bearing, to use as the point for the puller. I hope I have it set on the crankshaft end, however it is really on there and I am afraid if I add any more stress to the puller I will warp the clutch plate. I see no set screws, and as far as I can tell, there is no bolt at the end of the crankshaft holding the plate. Is it just on there hard? I am about to use heat but hesitate without talking to someone who has had it off. I know this is a longshot, but if you can help by telling me it's just on there hard, I will heat up the torch. Wondering in Seattle, Bill Guise
 
Bill,

I have a Speedcat and am looking for a new clutch and pressure plate, and also getting the flywheel off of the engine shaft. Were you successful with removing yours?
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top