Anonymous-0
Well-known Member
This message is a reply to an archived post by Ivan Leaders on October 03, 2000 at 17:18:04.
The original subject was "Re: Re: mead speedcat".
I am searching for an answer! You have had your mead Speeddcat apart and I am at a standstill! I have a puller on the clutch plate, with a bolt indside the pilot bearing, to use as the point for the puller. I hope I have it set on the crankshaft end, however it is really on there and I am afraid if I add any more stress to the puller I will warp the clutch plate. I see no set screws, and as far as I can tell, there is no bolt at the end of the crankshaft holding the plate. Is it just on there hard? I am about to use heat but hesitate without talking to someone who has had it off. I know this is a longshot, but if you can help by telling me it's just on there hard, I will heat up the torch. Wondering in Seattle, Bill Guise
The original subject was "Re: Re: mead speedcat".
I am searching for an answer! You have had your mead Speeddcat apart and I am at a standstill! I have a puller on the clutch plate, with a bolt indside the pilot bearing, to use as the point for the puller. I hope I have it set on the crankshaft end, however it is really on there and I am afraid if I add any more stress to the puller I will warp the clutch plate. I see no set screws, and as far as I can tell, there is no bolt at the end of the crankshaft holding the plate. Is it just on there hard? I am about to use heat but hesitate without talking to someone who has had it off. I know this is a longshot, but if you can help by telling me it's just on there hard, I will heat up the torch. Wondering in Seattle, Bill Guise