rear view mirror

zip on over to napa, get the rear view mirror adhesive kit. has a primer and an adhesive. clean the glass up real good, use a razor blade to clean off any old glue, do the same for the button on the rear view mirror. there is a small set screw that olds it it. lossen screw, remove button. follow glue directions. generally, prime both parts, let dry, then apply glue to button, press into place, hold for 30 seconds. when glue is fully bonded, re attach mirror.
 
Drop by your local glass shop and have them glue the mount back on. They have better glue than what comes in those kits and costs about the same. Last one I had done was 5 beans. Jf
 
When I worked at the Ford dealership, we had the local auto glass shop get us a kit like the one they used. Trick was, their kit used the same stuff as our Ford adhesive, BUT their kit also had an aerosol can of "accelerator" that allowed the adhesive to set up a lot faster. That was the ONLY difference between the stuff available at NAPA or AutoZoo and what the "professionals" use.

So use a razor blade to scrape off the old adhesive, after using a crayon to mark the position of the button on the OUTSIDE of the glass. Clean the inside with a razor blade, and then an alcohol pad to make sure there's no residue left. Then glue the BUTTON, minus the mirror, to the windshield, and hold it in place OVERNIGHT with masking tape, which is easily removed in the morning when you install the mirror back onto the button.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top