(800) 853-2651
SHOP NOW

Rebuild for D17

S

Stoegs

New User
I know this has been discussed before, and have read different forums and end up being confused. Gleaner E in a WD, what rebuild kit do I use, looking for.125 over and higher compression and no machining. What would be the best piston for pulling. Not planning on any other modifications.
Thanks Bill
 
Stoegs said:
I know this has been discussed before, and have read different forums and end up being confused. Gleaner E in a WD, what rebuild kit do I use, looking for.125 over and higher compression and no machining. What would be the best piston for pulling. Not planning on any other modifications.
Thanks Bill
Click to expand...
4 1/8 wd pistons,175 cam grind,175 gov spring,other than that,stock rebuild with d 17 specs,now go have fun!!
 
You must log in or register to reply here.

Similar threads

S
Gleaner E
Replies
4
Views
573
Stoegs
S
D
Gleaner E/Allis engine parts expert needed
Replies
8
Views
588
Jim.ME
J
D
Stuck WD; Convert, upgrade to D17 HP?
Replies
8
Views
439
cleddy
C
D
Allis WD-45, or D17 flywheel starter ring location?
Replies
15
Views
835
docmirror
D
D
governor spring
Replies
3
Views
546
dieselbob
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top