mnbryan

Member
I have an SC that was stuck and I was trying to get running. When we pulled the head we found a cracked block and cracked head. Does anyone know where to get a used SC motor? Can these be welded up? Nice little SC with a single wheel front and nice tin. I do not want to scrap it. Thanks in advance for any info!

Bryan
 
Where did it crack? That will depend if it is easily fixable or not. Replacement shouldn't be all that hard to find since people consider them as lessers than the DC.
 
When you say you discovered the cracked block after pulling the head, leads me to suspect that the cracks you discovered are in the webbing between the sleeves. If that is where the cracks are, don't worry about them. The head gasket will seal them.
It shouldn't be too difficult to locate another head.
 
if you need a motor ,,.i have a good sound sc motor ,,however it has been welded behind the carb ,, j.saelie is correct ,,you may not have a major problem
 
The Cracks are between the sleeves between #2 and #3. It did run fine 15 years ago when I bought it but unfortunatly, I did not do a good job of preventing it from locking up. I did not notice any oil in the water or water in the oil.
So, I just get a head, throw a new head gasket on it and call it good?

Thanks!

Bryan
 
Another question for all you experts, what would cause a block and head to crack like that? Did it get overheated at one time? It seems like that thing ran just fine all those years ago when I parked it. I know it did not get water in it. When we pulled the head it was dry, only one cylinder had some rust in it which is what cause it to sieze up. I may have been able to break it loose without pulling the head if I would have had more patience.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top