Sherman Step Up Parts

[Fred in Mi.]

I`m getting ready to install a Sherman Step Up soon in my 1940 9N "25213" and need a grommet,instlation shims and seal, I have been searching high and low for these few items, I mailed Red Rock but they sell the whole Sherman re-build package and others only have the grommet would anyone out there have these?
If so please e-mail me at [email protected]..
I wrote in before about my stuck valves and now have the head off and sure enough two on different cylinders are not closing at all and the others are not sealing well either. I`m waiting for my valve spring compressor to come in to finish that job.
This board is wonderful, you all have helped this old fart a lot, thanks again,

Fred

 

[souNdguy]

I believe jimNcal is the man you ar elooking for.

soundguy

 

[Fred in Mi.]

How do I get a hold of him.

Thanks sounduy,

Fred

 

[NOXJohn]

He posts om this board. Look below for one of his post. His email is normally open.

 

[John Smith8N]

The front seal is the same as the regular tractor uses, 8N7052 available about anywhere. The shims are same as used on the regular tractor transmission and are available at New Holland dealers.
C3NN7135A - .003"
C3NN7135B - .005"
C3NN7135C - .012
9N7086 - paper gasket
The grommet is available at external_link and probably other sites.

 

[Fred in Mi.]

Thanks again soundguy, I wasn`t paying attention to the names on here, I will now.

Fred

 

[souNdguy]

From what I see .. he's the go-to man for many aux trannies.

soundguy

 

[Anonymous-0]

i have all sherman parts

 

[Fred in Mi.]

Thanks everyone, looks like I`m in shape again, as soon as I get back from the saw bones today I`ll start looking for my parts and I`ll keep those address for future use.

What a wonderful board this is,

Fred