Now and than when I try to start my tractor (1955 Ford 800) it just goes click click click. So I loosen the 3 bolts pull the starter out about 1/2 " put it back and the tractor starts. Do I need a new starter or a new drive gear?
 
No, your not starting it correctly,what you are talking about is nomal sometime, if you are starting dont let off starter until it starts and that should not happen. very common on some tractors other than john deere.
 
Aw Herbert, Rick Deere is just teasing you to compensate for the fact that Deere is the Rube Goldberg champion of tractor starting systems.
(IE an electric starter to start a little gasoline engine, which IF it starts, then cranks the two popper diesel, or more recently a 24V system that eats a set of batteries every year and cannot support a 10 amp 12V accessory load.) ;-)

You likely have a slightly damaged ring gear and or starter drive in your Ford that allows the starter to jam in the ring gear. You can most often free up a stuck starter by putting the tractor in it's highest gear with the clutch engaged. Rock the tractor rearward by pushing on the front of a rear tire, to turn the engine backwards just a bit to unlock the starter, no need to unbolt it. This is a quick fix for any tractor that uses an inertia starter drive.
 
Sorry Rick Deere, I thought you were teasing Herbert by saying a jammed starter is normal for anything but a Deere tractor.
After reading your post a bit more carefully, I realize you were just trying to make a helpfull suggestion about not re engaging the starter if the engine is still turning. Good advice and sorry for my mistake.
 
Herbert, next time you have to take it off, use a wire brush or some emery cloth and clean up where the starter mates to the bell housing. If the the 800's are like the N's you might not have a good ground.
 
If the starter by now has many years and thousands of starts in it's history. And maybe even tinkered with. It doesn't owe you anything.
Rather than being left stranded. It's time to tear that starter down and replace everything that's worn. Maybe even add a set of high torque windings for next winter.
 
Could be a jammed start drive or it could be as simple as a poor ground and when you pull it you clean up the starter ground just long enough for it to work well. I would clean both the starter drive with brake cleaner and wire brush the area that the starter bolts to and see if your problem goes bye bye
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top