Stumped-C30 brakes

Mokicker

Member
Had a leaky wheel cylinder and master cylinder on my 1ton. Changed them out, adjusted brakes, bled brakes and still problem. Couple pumps and have full, solid pedal. Let sit few seconds and goes to the floor. 94 chevy 3500, disc front, drum rear.

Any ideas.
 
Try holding the pedal down after you pump it up if it holds then air in system if it goes down to floor then bad master cylinder. You will have to hold it down hard or if it starts to hold then fades off suddenly bad master cylinder.
 
Let me start by saying that I have made mistakes, myself, but it sounds as if you did not completely bench bleed the master cylinder. I, NOW bench bleed these by bolting the master cylinder in place and bleeding them COMPLETELY, prior to reinstalling the lines. If this is the case, let your truck sit overnight with a full reseviour of brake fluid and bleed them tomorrow. It may still take awhile, but most of the air should settle to either the bottom(calipars, slave cylinders)or the top(master cylinder).
 
Double , triple check . Rear brake adjustment , slight drag as you turn drum . Rebleed it, often I will use a pop bottle and piece of tubing , open bleeder, push hose over nipple ,needs to fit tight , other end of tube in bottle, make sure end of hose is covered with brake fluid . Slowly pump pedal, keep pumping till no bubbles. Also look at all rubber brake hoses while someone pumps brakes , they fail internally at times, will see bulge .
 
If you pump a dry MC to hard you can put air in the brake fulid. Let it set a day and SLOWLY pump the brakes. I bet you find air.

Kent
 
If you don't have a pressure bleeder, try pointing the truck down hill so the air in the line works its way to the back wheels. Pressure Bleeder can be made from a cheap plastic handheld weed sprayer.
 
Thanks to all.

Common sense told me it was air. Got back to it today and and after two hours of running lines checking fittings, etc, found a fitting on original line that was apparently not seating squarely. Replaced fitting and bleed right out. I just bought the truck; so, no telling what else I'll find that's not quite right.

As always, you guys helped me keep my sanity.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top