Testing a glow plug

Anonymous-0

Well-known Member
Can some one tell me how I can test the glow plugs on my skidsteer. I tested them before and I guess old age is setting in as I don't remember how I did it.
 
Disconnect the power lead from the glowplug.

Connect the alligator clip on a nonpowered 12 Volt testlight to the battery's (+) terminal.

Verify the test light works by touching it's probe to chassis ground...light will light.

Then, touch it to the terminal on the glow plug.If the glow plug is not "open", the test light will light.

This is NOT a 100% test the glowplug is 100% "up to par", but usually, they either work, or are "open".

If you have an "in-line" DC ammeter of enough capacity, or a "clamp-on" DC ammeter, you can check the current drawn by each GP, and note that they are all drawing close to the same current.
 
You mean "infinity" (OPEN) is BAD.

A (cold) GOOD GP will test @ nearly zero Ohms with the average Ohmmeter.

Of course, a TRUE reading of exactly ZERO would mean it's shorted, but, in that case, likely a fuse, wire or fusible link would ALREADY have "smoked".

'Most ALL the time, GP's fail "OPEN", rather than "shorted".
 
Some will read 1 ohm cold (like my Izuzu) some 2 ohms - it all depends what engine and what type of glow plug (single coil or PTC self regulating).
New glow plugs for my GM 6.2 diesel will read 3 ohms when cold.

The only universal way to make sure a glow plug is working is feed power to it and see if it draws current. You can do it through an amp meter and see how much - or - just touch a hot wire to it for a second and see if it sparks. If it sparks, it's taking current - if it does nothing the plug is dead. Just be careful you don't put too much voltage to them, some run at very low voltage rates. E.g.,the glow plugs in my IH tractors are only rated at 9/10ths of a volt each.
 
I agree with Bob on the test light method, it will tell you quickly whether they are open or not. If you have them out to test them don"t hold them and power them up to see if they get warm as they go from iced cold to red hot with no in between. Guess how I know that. HTH, Jf
 
Hey fella, On my Powerstroke the good plugs measured .9-1.2 ohms. The bad ones measure 60-70 ohms. I should mention that all plugs passed the test light method. Starts great now. Get out you ohm meter and test them and I bet you will find on that doesn't match the others. Replace it.

Just hope the other three aren't bad and you replace the only good one...

It would be my luck,

Aaron
 
Putting 12V on the glow plug and measuring current is the only accurate method.
Ordinary ohm meters and their operators are not accurate below 10ohms.
A glow plug may measure ok cold with an ohm meter but fail as it warms up.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top