Testing alternators

grandpa Love

Well-known Member
Some how I have ended up with 7 or 8 alternators in a pile under my work bench. I needed one for a cub today, took 3 to AutoZone for testing, guy was a jerk. Obviously didn't want to test them. Got really rude when I answered his question about what vehicle they came off. Told him a Farmall tractor but I would think '80s Chevy. Several smart comments later he tested them , surprise, they were all bad. This is an older guy who is friendly most of the time,been there years. I bought a new alternator because I needed one, but got to wondering what does it benefit the store to say they test good, unless it's under warranty?? Stopped at O'Reilly's and they told the youngest, newest employee to test them, 30 minutes later I told him to forget it and left, he never could figure it out and none of the managers would help, even joked about me wasting his time not theirs. So..... Any way to test alternators at home? Not on a vehicle or tractor?
 
It's the same way getting batteries tested! The place tests them, tells you it's bad, and tries to sell you a new one! I took a supposedly bad battery home and used it another 2 years in our Farmall C.
 
One way is to put a volt meter on the battery wire and see if you get smewhere around 13.5-15 volts if not then there is a problem You can also try the magnetic method for an idea of if they even work at all. Try a draw pin or moderate bar and see if it sticks to the center of the back end by the shaft bearing. Not a scientific method but rough idea.
 
You can do a rough idea test at home.

You'll need to have a 12v battery with somewhat of a charge in it, and a volt meter.

A harness plug for the 2 terminals in the side. Run both wires to the BAT post of the alternator.

A wire from the BAT terminal to the + battery post.

A wire from the alternator case to the - battery post.

Connect the volt meter across the battery.

Now you need a way to spin the alternator. You can get fancy and build a bracket and belt it to an electric motor, I would say at least a 1/4 HP, or the red/green method, hold the pulley fan against a wire brush on the bench grinder. It does not matter which way it spins.

If it's working, you will feel resistance against the spinning if you are holding it. You will also see the voltage climbing across the battery terminals.

As said, it's not a true test, it can have output problems, it can have regulator problems, but it will give you an idea if it is trying to function.
 
If you're talking about a 10si you can put it in the vise, supply 12V + to both terminals 1 &2 (field & regulator), ground, or minus to the case of the alternator, or vise. Connect a 12V bulb with pigtail to the Battery terminal on the alternator and again ground it to the alternator casing, or vise, and turn over the alternator pulley, direction doesn't matter. It's usually enough to spin it over by hand as fast as you can to get the bulb glowing. You can opt to get a piece of hex stock, or socket, connect to a drill and stick it in the center of the pulley, or on the nut holding in the pulley if you're using a socket and spin it. Make sure the bulb you're using is good.
 
No one has mentioned the fact that you can ground the fields though a hole in the back of the case and if alternator is good it will charge full output and that will tell you there is a regulator problem.
 
If the alternator is on an engine that's running, a quick way to test it is to hold a small screwdriver, or even a hacksaw blade, against the rear bearing.

If the alternator is charging, it will pull at the screwdriver like a magnet.
 
When I worked for NAPA I never bought a battery. When I needed one I would go through the core pallet and find one that tested good. Replaced it with my dead one. NAPA had their core, I had a good battery.

On a side note we quickly learned which shops were not exactly honest with their customers. One Nisson dealer comes to mind. You could bet ninety percent of their cores were still good.
 
You could do this, except with alternator (washing machine motor & stick belt tensioner)
W1pibeY.jpg
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top