tractor accident

Anonymous-0

Well-known Member
Many years ago when I was 14 years old I was by
myself and attempted to unhook a implment from our
8n Ford. I had on a pair wet levies. I swung my right leg over the back of the tractor seat to kick the lift arm off the implement pin. A bolt
in the pto wound me up on the pto so tight over
the seat, it stalled the motor. The bolt chewed
up my leg pretty good. I finally got my thoughts
together,leaned back and put the pto out of gear.
I unwound myself. I walked in the house, my Mother
took one look at my leg and fainted.
 
I had not really an accident,but kind of a stop have a smoke and change your shorts kind of moment. I was grading the drive,it was kind of chilly so I had a jacket on. Once it started to get warmer I took the jacket off and spread it on the seat and sat on it. About 15 minutes later the sleeve got hung up on the zerk of the ORC. That PTO snatched that jacket out from under me and almost took me with it over the back.
Things like that tend to make you slow down and think things thru a bit more thoroughly!
 
I was working with a guy that got a sleeve caught by a part in a large lathe. One minute he was standing there in a white shirt, next he was naked from the waist up, the shirt was spinning on the lathe. Very lucky.
 
I was only at my first job (machine shop) and I was in back grinding burrs off of some small gears we were making for Arctic Cat 4 wheelers. To get the burrs off, the easiest wasy was to have a small shatf in your hand (with a glove on) and a washer over your hand, then the gear, and then another washer/plate to hold it on the shaft and control how fats it spun.

Then you stick your fist through the belts on the belt sander and hold the gear against the belt. I must have stuck my pinky out and the glove got caught between the belt and the pulley on the sander. Ripped the pinky right off my leather work glove. I honestly don't know if my pinky made the trip around the pulley or not. It all happened so fast all I could do was stare where the pinky on the glove used to be and make sure mine was still there.

7 years later, I'm still alive and have all of my limbs. Do have a few scars though.

Donovan from Wisconsin
 
a friend of mine was taking his uncles massey 44 to rake hay with a pto driven rake.
the front half of the pto shaft was attached to shaft on tractor and was turning. i said to him shouldn't you do something about that?
he said no it will be okay. about that time he hit a hole in the lane the shaft bounced up and whacked the light off of fender. he said that could have been bad!
his uncle was hot!
 
Forty some years ago when I still lived at home with my folks on the farm, my dad was called to the neighbors place in the next section. The neighbor was chopping stalks and had fallen off the tractor seat and into the chopper. The tractor had stalled at the end of the field in the fence. My dad said that was the most terrible thing he had seen in his life, helping remove the neighbors remains from that terrible accident. Be careful and safe, that was the same era tractor and equipment as many folks including myself use today as a hobby to keep in touch with the usually "Good Old Days".
 
this happend h=just a few years ago now but when dad was baling hay with out JD 24T kicker baler for some reason the bale it trew landed back on the pan or whatever so dad hopped off the tractor (without shutting the PTO off) and grabbed the bale offa the kicker. the kicker kicked and threw him back against the wagon and left a 2 inch gash in his neck kinda between his adams apple and his jugular. to this day he will tell you he has no idea why he didnt shut the PTO off. another story. my nieghbor is missing his middle through pinky fingers at the knuckel. he was chopping with a flail chopper and something went wrong. he sut the machine off but didnt wait for it to stop before he reached underneath. took his fingers right off like nothing. one neighbor is missing a leg because of trying to step over top of a PTO shaft on a chopperbox. have more stories but point taken on my part. ALWAYS shut the PTO off and let it stop spinning before getting off the tractor!
M puller in WI
 
almost everybody had or gonna have a close call once in a while, i got a few of my own.
Once,i was skidding a big log out of the woods behind my tractor,the log snatched on a stump,the chain hook pin broke and send that hook trough my rear window,grazed my ear and went out trough the side door window to stop 2" deep in a tree.
2" over the wrong way and i would not be writing this.
 
Spook, where did that happen? I know of a simular incident. Happened just before my shift, on the very lathe I would be operating. Helper on the lathe got too close to the material sticking out the through hole at the back side of the chuck. Caught his clothing, spun him around 3 times, just missing steel & concrete, and slammed him on the concrete floor. He got up, and walked into the restroom with only his work boots on. Other than his whole body being black & blue from the tightening of his clothes just before they were ripped off, he didn't have any injuries. Very lucky he wasn't killed.
 
Wouldn't have happened on an AC, snap couple means you don't have to get off the seat to hook up, except the pto shaft. And when you hook that up, you turn the motor off!
 
When I first got my First Ford 800 I decided to see how well it would pull trees out. I hooked the chain to the cross bar (My Bad). The first tree (must have been rotted) pulled out nice. The second tree had my tractor up at almost 90 degrees. I never did that again!
 
Back in the early sixties when I was about 14 I helped pull a man out from under an overturned Farmall M and carry him up the side of the road ditch to the ambulance. He died the next day. My knees were shaking so bad I had to sit down afterward. It made me a safe tractor driver at a young age, at the expense of his life. Jim
 
First think I was taught in "A" school in the Navy was to roll those sleeves up as high as you can and tuck in any loose clothing and never, never wear a tie.
Walt
 
When Grandpa was a yungin, He got too close to a running thresher belt. The static from the belt pulled his overalls or shirt up to the belt where the lacing grabbed them and tore them right off his body and left him standing there with not a lot left on. Good thing the overalls were old ones but he was still badly bruised up and a lot wiser. He farmed all his life and I think it was due to that accident that he paid close attention to what he was doing in the future and stayed clear for moving shafts and machinery. He had all 10 fingers when he passed. I also knew a fellow who survived a trip into a corn picker. He had missing limbs and tons of scars but was still very lucky as most people who made that trip didn't come out alive.
 
Because of breakdown of my normal baling tractor, I had to bale with an IH W4 once. You sit out over the back, and the PTO shaft comes between your legs. Of course, my baler PTO shaft didn't have any shielding, and I could see it was a disaster waiting to happen- so I duct-taped my overall legs to keep them from flapping. No problems, but I had to make a conscious effort to keep my feet out against the fenders so my leg wouldn't stray into the center when I was turning and watching the baler. If someone manufactured a tractor with that kind of design today, the lawyers would have a field day.
 
About the pto accident. I had been irrigating and
had my pants leg rolled up a couple of turns.
My left foot was still on the left running board.
I had swung my right leg over the back of the seat
when the pto grabbed me. It pulled me down over
the seat so hard it stalled the motor. At the time
we were having a good ol west texas sandstorm.
 
The P-39 Airacobra had the engine behind the pilot with the drive shaft going between the pilots legs. Interestingly enough, it's main armament was made by Oldsmobile. It fired through the propeller hub.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top