Tractor picture

grandpa Love

Well-known Member
Used the fords to load scrap metal yesterday. One had a boom pole, one pulled a trailer from the back 40.
cvphoto105495.jpg

I could have parked them anywhere else but I thought Larry needed to see the fresh plowed garden!
cvphoto105496.jpg

Hauled off 2 loads of scrap. Around 8000 lbs, only $560. But it cleaned up around here. Picture for ytdot!
 
Welder had a rod come through the side of block. No way to repower it with a harbor freight motor. Cousin got it for free. Gave up. Gave it to me .....
 
What was the cost of an engine from the same manufacturer for the welder or did you have to go through Miller for it. A 8-10,000.00 dollar welder would justify some expense for an engine compared to a new one.
 
There is a re-power for those. That one probably was an Onan powered trailblazer or bobcat series. Very good welders, the genset is of good quality. The re-power is around $3k and they'll help you from the technical side to get it done.
I have 3 of these welders, 1 Onan powered trailblazer NT251, the other 2 are Bobcat 225's. One of those has an Onan, the other might be a Kohler, but not a K series. Shop where I worked for years, was tossing them into the dumpster, I had found spare tin from even another they had, owner said take em all, I did, but honestly really only needed the tin. I may fool with at least one of them.
Miller Re Power
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top