super99
Well-known Member
I have an older P&J gooseneck that I haul my 1550 on. A couple of weeks ago, I hauled the tractor to a ride 60 miles away. Evidently I didn't get the plug in far enough to catch the latch and it came out and when I arrived, all I had was a wire dragging on the ground. I borrowed a pickup and drove into town and got a new plug in for the trailer, came back and wired it up correctly and came home. I'm not sure, I don't think the brakes were working then. This afternoon, I hooked up the trailer and plugged it in and I don't get a light on the brake controller. I had my wife watch the light while I checked the plug with a test light. When I touch the tester to the brake prong, it lights up, so I think the wiring is good to the rear of the truck, all trailer lights work as should. I took the trailer plug apart and get nothing with the test light when the brakes are applied. It has to be something on the trailer causing the problem, correct?? I followed the wires under the trailer and all seems good. I took the cover off of the junction box on the trailer and tried the test light and got nothing on any of the studs. The only difference is I greased the ball on the truck before I hooked up the trailer. I thought that the trailer wiring had a ground included so the grease shouldn't make any difference should it?? I'm lost!!