Trailer Brakes

1 Dollar

Member
I've got a tandem axle utility trailer that the electric brakes do not work on. It originally had 1 brake axle. I just added the brakes to the rear axle as well as trying to get the front axle brakes to work again. Of the 4 drums, I think they all buzz, and 1 actually locks up (driver side, front axle) when I freely spin the tires. They are all adjusted tight to the point or dragging some. Does the problem lie in the wiring? They are not backwards; the actuator arm is facing forward on all 4. The supplier I got the new hub/drums from said just wire in the new ones, doesn't matter which magnet wire goes to ground and hot.

This is just confusing me since 1 of them is actually working

Thanks
 
Most likely a poor ground. Wire the grounds back throught the trailer connector as well as grounding through the frame.
 
Joe's right almost all problems like this are related to grounds. Double and triple check all grounds. and make sure your controller is rated for the amperage you will be drawing.
 
As mentioned, and in accordance with my experience, more'n 90% of all trailer electrical issues are ground related.

But. A few years ago, while I was having problems with newly replaced trailer brakes, i contacted Dexter and was told electric brakes have a break-in period. According to them, it takes 25 to 50 "cycles" to wear in new magnets, shoes, ect.

Check current from hot wire, through ground wire at all 4 corners to make certain all are equal. If so, I'd try towing an EMPTY trailer a few miles and using the brakes frequently to see if they wear in.
 
Well I was pretty confident in my wiring (Crimped insulated butt connectors, Not scotch locks, I hate them too) so I took MF Poor's advice and went for a drive down the gravel roads. They all started working. The gravel allowed me to lock them up and not smoke the tires every time.

The trailer is only about 1000lbs empty so its kind of hard to tell if the brakes are working before lockup since that trailer wont stop my truck. Loaded up the heavy electric golf cart and some suitcase weights and I could stop great.

Thanks for the help
 
you can figure 3 amps per magnet or 6 amps per axle..per the dexter site.
so you need to pull 12 amps for a tandum...

meaning that your wire is probably too small. too small in the truck and too small on the trailer. so 16 ga will no longer be the right wire for maximum braking. bump it to 12 ga..
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top