Tuesday Truck Pic

kcm.MN

Well-known Member
Location
NW Minnesota
Puzzle: https://jigex.com/Hw6nL

mvphoto83371.jpg
 
I would like that truck too, upgraded to all of today's bells and whistles.
Wish today's trucks were step-sides.
 
I had a 56 3/4 ton with grain sides on the box. Went to the local sand plant one time pulling a trailer. Asked for 2 1/2 ton. The operator dumped what looked like a ton in the trailer, got another scoop and began dumping into the truck. I was standing in front, and it seemed like he was putting a lot in there so I walked around and looked. The sand was piled half way up the grain sides.
I frantically wave for him to stop.
He jumped out to see what was wrong, then told me it wasn't even close to the overloads yet.
Rolled across the scale at 14,300 net on load.
The truck pulled it fine, but didn't like to stop much. Rode a lot better with the load too
That truck started life with a 272. When I got it, it had a 292 taken from a school bus.
That was far from the only time I loaded her a touch heavy. Back then, Ford tough was an understatement.
When I sold it, all the sheetmetal was still straight, and the only rust hole was in the running board.
 
Had to look left to run the combine.


We had a 65" F-100, I think the doors might have interchanged, the color is an exact match, for sure.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top