UB timing marks

[Anonymous-0]

Where do I find the marks on a UB? I cant' find any hole or cover around the bellhousing to see them. Thanks!

 

[Curt Cooke]

I think the only cover you get is one on the left side about 2" by 4" and is held in place with 4 bolts (3/8" course. After that the only timing mark you'll find is TDC. You have to make your own timing marks if you want more. I suggest a paint pencil for that.

 

[MMfan]

The cover is on the bellhousing, left side of tractor at about 2:00,Most I have seen have 2 small bolts holding it on. The steering rod sometimes passes right across the cover. 2"x4".

 

[Philip moline]

Pump should time at 27 degrees before top dead center there is a cover on the right side of the flywheel housing (4 bolt cover ) bar engine over until you see INJ then take the inspection plug from the top of the pump adapter housing and the pointer on pump will line up with the line on the drive gear.

 

[Anonymous-0]

I found it and figured it out. Thanks to who replied. Oh by the way it's a gas not a diesel...