Adirondack case guy
Well-known Member
I have had my eye on this snow blade for more than a year now. Back last winter when I built the grill guard for the 440, I built the base of it with an 8" channel iron which is now going to be the main push/mtg frame for the plow. The plow's lifting mast bolted onto my grill guard perfrctly. I will weld and bolt in a a reinforcement bracket. I will also weld struts to the back of the channel extending back to the bellhousing, taking any stress loads off of the engine block. The whole push/pivot assy. tucks back under the nose of the tractor, and I think it will make a real nice setup.
I have two 1.5x6" double acting hyd cilinders that I will also fab onto the push frame at some point. It now has a removable pin to angle the blade.
Loren
I have two 1.5x6" double acting hyd cilinders that I will also fab onto the push frame at some point. It now has a removable pin to angle the blade.
Loren