WANTED: Coop E4 input shaft

[dodgeboy02]

I am looking for an input shaft to fit a coop E4. The one in mine is over half worn down on the splines, I would guess it will not hold up. Does anyone have or know where one would be? Any help is greatly appreciated. I am also looking for a gleaner combine engine, from a model A or C combine. Thanks
Blake
701-320-6061 or [email protected]

 

[cj in wisconsin]

I have a complete trans and rear end for one. But it is snowed under, I am in northern Wisconsin.
715 566 1145 Leave a message if u r interested

 

[Anonymous-0]

I really just need the input shaft, would you pull it out quick? Im in south ND. Thanks

 

[cj in wisconsin]

I'll see if I can this weekend, they are predicting a bad storm, but it should be no problem.

 

[dodgeboy02]

Yeah we're supposed to get a beauty this weekend too. See if you can get it out and let me know. I appreciate it much,

Blake
701-320-6061

 

[Anonymous-0]

Actually, I need the retainer as well, mine is cracked. What is the small shaft on the inside of the larger shaft? That is the one that is real bad, I pulled on this one and it pulled out, how does it slide back in? How much would you need for this setup. Email me at [email protected] or call me at 701-320-6061. Thanks a bunch

 

[cj in wisconsin]

I ran out of time this weekend but tomorrow I will pull the whole works. Inner shaft is for the live pto outer is the clutch shaft. I will call when I check it to make sure it is serviceable. Thanks for your patience.

 

[Anonymous-0]

No problem at all. Thanks alot for your help. Let me know when you get time. Thank again

Blake

 

[Anonymous-0]

Hey there, I think my pto imput shaft will work out ok, I do need the retaining cone for the imput shaft. Just wondering if you had a chance to pull that out. Thanks again,
Blake

 

[jimvw]

I would have one. I have lots of Cockshutt parts. Located in west central Minn.

 

[Anonymous-0]

Great whats your phone number? What town are you located by? Thanks

Blake