Water in transmission

Twisted_Steel

Member
Location
Monroe, NC
My neighbor has a 1957 Massey Ferguson. He checked his hydraulic fluid and it is yellow as all get out. We've drained the fluid.
I replaced the busted rubber boots on both shifters, so that should stop the water getting into it. He says he'll store it over the winter in a shed.
What's the best way to get as much contaminated fluid out of the tractor as possible?
I told him I'd ask here before we go pumping varsol or diesel into it.
 

Attachments

  • 20261119_163245.jpg
    20261119_163245.jpg
    1.2 MB · Views: 0
My neighbor has a 1957 Massey Ferguson. He checked his hydraulic fluid and it is yellow as all get out. We've drained the fluid.
I replaced the busted rubber boots on both shifters, so that should stop the water getting into it. He says he'll store it over the winter in a shed.
What's the best way to get as much contaminated fluid out of the tractor as possible?
I told him I'd ask here before we go pumping varsol or diesel into it.
Take it out and work it, get it up to temperature then drain it and leave it overnight.

Does it have a loader or is it a bare tractor? Multiple changes may be required to clear it. Working it and getting it up to temperature regularly to evaporate water out of the fluid off will help. Short runs and weather changes will add condensation.

Adding diesel or varsol can leave pockets of those in place of the water, they will thin the oil as well.
 
No loader just a bare tractor. We've already drained the oil/water combo out.
He's 77 and fixed income. He bought 7 gallons of 85/90 @ $135.00 today and can't afford another hit like that.
I have a sprayer that hooks to my air compressor and pulls fluid out of a jug. Is it possible to spray gas into it to wash it out and let the gas evaporate?
Here's a pic of the dipstick. The first post shows the oil in a tote. It looks like a sheet of cardboard laying in the bottom.
 

Attachments

  • 20261118_195050.jpg
    20261118_195050.jpg
    1 MB · Views: 0
What model 1957 Massey Ferguson?

I expect straight 80 weight mineral oil would have been the original spec as the transmission is the hydraulic reservoir. If he has been running 85W/90 for years just dump it in and go. What little contaminated oil remains in pockets will spread through the new, anything you spray in will stay in those pockets and mix with the contaminated oil in them. I would rather dump 3-4 gallons of cheap engine oil in it run it for a bit, cycling the hydraulics then dump that out and see how milky that comes out. Just my opinion and thoughts, others will differ, no problems each to their own.
 
Don't think I would add gasoline to the transmission. It could damage the seals.

I have used cheap straight 30 weight engine oil a few times. Fill it with oil. Work the tractor lightly until it's warm then drain. Repeat. Then fill it back up with the oil it calls for.
 
What model 1957 Massey Ferguson?

I expect straight 80 weight mineral oil would have been the original spec as the transmission is the hydraulic reservoir. If he has been running 85W/90 for years just dump it in and go. What little contaminated oil remains in pockets will spread through the new, anything you spray in will stay in those pockets and mix with the contaminated oil in them. I would rather dump 3-4 gallons of cheap engine oil in it run it for a bit, cycling the hydraulics then dump that out and see how milky that comes out. Just my opinion and thoughts, others will differ, no problems each to their own.
Here are pics of the cap on the transmission. It calls for 90w in summer and 80w in winter.
I'll check with him tomorrow and see if he has some old oil. He had 5 gallon cans of 10w30 and some hydraulic oil.
 

Attachments

  • 20261119_175804.jpg
    20261119_175804.jpg
    1.6 MB · Views: 0
  • 20261119_175731.jpg
    20261119_175731.jpg
    1.7 MB · Views: 0
That vintage used mineral oil, which is not the same as current gear oils. Weight is about the same, additives are different. There is no W after the weights on that cap. Some are running UTHF in these units now.

Again, what model is the tractor? In 1957 Massey Ferguson, Massey Harris, and Ferguson had some shared models, as the three were one at that time.

As I said if he has been running 85W/90 in it right along, that is his choice. I am just relaying what I see in a Massey Ferguson Operator's manual of that vintage.
 
Massey Harris and Ferguson were together at that point. Just to be clear, a TO 35 is a Ferguson model, not a Massey Harris or Massey Ferguson model. Ferguson had and sold their models and Massey Harris had their own models. Then when the Massey Ferguson joined, another was added. In some cases, the same tractor was sold under three different model numbers, one for each entity.

The Ferguson TO 35 Operator's Manual calls for straight mineral gear oil. SAE 90 above 50 degrees and SAE 8 below 50 degrees. His choice on what he chooses to run; gear oil, mineral oil, or UTHF.

The manual shows two drain plugs, one on the left side about straight down from the pitman arm on the steering box at the lower side of the transmission case and the second on the underside of the differential case. Did you drain both?

Here is a link to a Ferguson TO 35 Operator's manual, if you want for reference.

Ferguson TO 35 Operator's manual

Cheap engine oil is a better way to flush the housings in my opinion. In fact, some of the earlier Ferguson manuals allowed SAE 50 engine oil as a sub for the 90 and SAE 40 for the 80.

The number before the W is actually to signify the oils viscosity at low temperatures. No W is the oil's viscosity at higher operating temperatures.
 
What I do if you can let tractor sit for a a couple of weeks at least I would fill with new oil and mix thourghly. Let tractor sit for at least 2 weeks. Then crack the drain and watch water drip out. Water separates given time and goes to bottom.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top