WC killswitch for Mag

[Anonymous-0]

I have an WC with a mag. The factory killswitch lever is gone is there a way to wire up one??? Any help would be greatly apprciated!!

 

[JMS/.MN]

Should be a little bolt coming out of the right side of the mag, where the metal kill strip used to be. Wire your switch to that. Usually had a simple push-pull switch to ground it out.

 

[John T]

You just have to get a stud/terminal to the outside insulated from the case of course..... The kill wire attaches to the points then out via the insulated stud then if its grounded out it kills the spark

John T

 

[Jeff Z.]

I have a magneto push/pull switch brand new if you want it. No Charge.
Email your address.

 

[Steve in NJ]

We offer a Mag Kill Switch kit for the RC/WC models that didn't have a remote switch near the driver. Also have the OEM single pole self grounding switch to. If interested drop a line. Be glad to help ya out...

Steve@B&B

 

[Normspeed]

Another killswitch question..I have a WC with a different mag. It's a K type, with the one piece cap instead of two piece. There is a small stud at the bottom of the cap for grounding out to kill the ignition. But I'm not clear on how this hooks up inside the mag. The inside part looks like it was supposed to touch the points when the cap is in place Is there supposed to be a more positive connection, like a wire inside connecting the kill stud to the points?