WD with a stuck piston

Anonymous-0

Well-known Member
I was finally able to move this piston after soaking it with CLR. Of course, I removed the rod bearings before CLR treatment. NOTHING else worked. Now, I can't move piston up to get it out to check (& probably replace) rings. Any advice? All replies are appreciated. Thanks, Mike Nassif
 
Spin the crank to a point that rod will hang out in the open then take a piece of wood and tap the piston up and out. Or if you can't turn the crank to that point take a small piece of wood and tap on the rod where the bolts are. Also filling that cylinder with ATF and a table spoon of gas then light it up will help also if you have it some place that would be safe to do that
Hobby farm
 
I'll ad to Old's comment that getting it below the ridge left by the upper piston ring, then using a ridge reamer on it will allow it to move up and out.
Without this it will for sure break something you need, The piston rings are still stuck in their lands, and will not get past the ridge. JimN
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top