Theoneandonlybrooks
New User
I have a John Deere 60 that I inherited. I recently picked up a used 801 3-point for it, but my rock shafts aren't turning. After some research, mainly here, I realized that I need the plugs to replace the hydraulic outlets. I haven't seen any that have the additional hookup on the side, however, so my question is, do I need two of them or three, and which part numbers?
I should add that I'm not 100% sure that's the issue. The rockshafts are near the top of their movement I believe. I can turn them down a bit with a big pipe wrench, but there is almost spring-like resistance, and they come right back up. The attached pic shows the setup. Thanks for any help you can provide.
I should add that I'm not 100% sure that's the issue. The rockshafts are near the top of their movement I believe. I can turn them down a bit with a big pipe wrench, but there is almost spring-like resistance, and they come right back up. The attached pic shows the setup. Thanks for any help you can provide.